1.1.6 build fails on FC30

[Achim Gratz]

Udo van den Heuvel via devel writes:
> refclock nmea unit 0 mode 7 flag3 0 flag2 0 flag1 1 time1 0.00000006 time2 0.260 baud 4800

Your time1 value doesn't make any sense.  You should use the highest
baud rate you can configure on your device, if you need to stick with
4800 you must restrict the mesage type so that the GPS actually can send
all data well before the second is over.  Last and most importantly, I
believe you showed before that you get your PPS in via serial line
discipline.  If so, you must use the clear edge of the PPS (flag2 1).


Regards,
Achim.
-- 
+<[Q+ Matrix-12 WAVE#46+305 Neuron microQkb Andromeda XTk Blofeld]>+

Samples for the Waldorf Blofeld:
http://Synth.Stromeko.net/Downloads.html#BlofeldSamplesExtra